Open a web browser and access the router's Web Interface. Click on the Configuration () menu on the far left and go to Network > LAN. Change the default IP (192.168.1.1) to something difference, such as 192.168.100.1. Click the " Apply " button to save the settings. Initial setup walkthrough for NBG-419N router This walkthrough describes the On desktop computer (s) connect the adapter to the rear ports. Issue may be related to USB bus for front ports. Update USB controller drivers. (Check motherboard/logic board manufacturer OR computer manufacturer website for latest drivers) Make sure adapter is plugged in correctly (light should turn ON when adapter gets powered. If your 5G signal is really low, it will automatically connect to 4G because you will get a more stable connection, and maybe even faster connection. However, if you force the 5G signal, it could result in a really unstable connection. So we recommend to have it set to Auto. NR5101 / FWA510 Setting the router to Bridge mode (IP Passthrough mode) ZyXEL VMG8825-T50. The ZyXEL VMG8825-T50 is a cheap but modern modem/router that is provided by ISP 's. It supports ADSL, and has an ethernet WAN port. The device has built in Wifi 2.4/5Ghz with support up to Wifi AC. It has 4 ethernet port for the LAN network, one USB 2.0 port and one usb 3.0 port. The firmware on it is fairly restrictive, but To this modem, I have a router connected in Lan1 (productname: ZyXEL). So my Huawai gets the internet and passes it on to my ZyXEL. I'm connected to the wireless-LAN on the ZyXEL. I'm using this setup, since the wireless-signal on the ZyXEL is stronger than on the Huawai (and the ZyXEL can't connect to the internet). Zyxel access points can be managed either in standalone mode or in Nebula cloud-managed mode. Users can configure the device using its local web interface. T That might do it or else from admin elevated command prompt once you have the ZyXEL configured accordingly and ensure the wifi access point or router is connected accordingly to the correct ZyXEL network or port run ipconfig /release and then ipconfig /renew assuming you are working with a Windows 10 client connected machine. Be sure you have Ensure that none of the cables is loose or wonky. Confirm that the power outlet is working properly. If you’re using battery-powered WiFi cameras, check if the battery is charged. If not, replace the battery and try again. Usually, most wireless IP cameras come with status LED lights, to see if the power lights are on. And try to ping the IP address of the adapter and the gateway of the main router. To locate the root cause, please connect your computer to the main router directly, bypass the TP-Link adapter and verify whether you can get internet; You can try to change another wall socket to plug them to test the stability and you can locate them in the same I've been trying to use my Zyxel P660 as a modem only: Setup P660 to bridge mode. Changed WRT54GL's IP address to 192.168.2.1 to avoid a conflict on the network. Configured the PPPoE settings as required on WRT54GL. The thing is that when I connect the Zyxel modem/router on the WRT54GL's internet port the light doesn't turn on. MIjbXEz.